News
Current Position： Home
> News
The high temperature pump should be checked when the natural gas mold temperature machine is installed
announcer：
When it comes to the installation of natural gas mold temperature machine, we must first pay attention to it. In fact, it should be direct. Just check whether the high temperature pump itself reverses before installation. On the day, the high temperature pump of the gas mold temperature machine appeared When reversing the situation, we actually need to directly replace the wire connecting the high temperature pump and the thermal overload relay.
What we will talk about next is that we should pay attention to that we should directly inject the heat transfer medium into the mold temperature machine system. For this point, we actually need to pay attention to the injection of heat transfer into the mold temperature machine. After the medium, in fact, it should be the circulation pump, but there is no need to increase the temperature. Wait until the heat transfer medium in the natural gas mold temperature controller system is full, and then increase the temperature.
As for the temperature control machine on the natural gas mold temperature machine, we actually should pay attention to whether it should be directly installed before the mold temperature machine, that is, it should be directly checked whether the circuit is connected, and then, observe whether it is There is a case where the circuit is reversed or missing a series.
In terms of domestic manufacturers of relatively good natural gas mold temperature controllers, we will actually notice that it is actually equipped with a circuit reverse phase or phase loss protection function, when such a situation occurs For the natural gas mold temperature machine, it will automatically send out an alarm. Next, in fact, we need to directly check whether the level protection function of the mold temperature machine is stable.
When the gas mold temperature controller issued an alarm signal that day, it means that the function of the liquid level sensor has been stabilized. When it does not emit an alarm, we actually need to pay attention to the sensor head on the liquid level sensor. After taking it out directly to change the direction, it can be tested again. If the natural gas mold temperature controller has not yet issued an alarm, we should also check the circuit.